Rotating Analysis


Order Tracking Analysis

Order analysis and tracking techniques are essential in measurements with varying rotating speeds. Getting correct results from run-up/down requires specific signal processing techniques.


Turbomachinery Vibration Solution: ORBIGate

ORBIGate is the dedicated software module for industrial rotating machinery vibration during diagnostics as well as acceptance works. Easy to use, it provides all the tools to bring the highest level of set-up simplicity and efficiency to the user.

Featuring simultaneous portable acquisition on up to 32 dynamic channels, an entire machine train can be tested during transients or steady states. The system acquires and analyzes orbit, Bode, shaft and casing vibration. Typical graphics are orbits, shaft centerline, spectra, Bode and polar diagrams, trends, waterfall, overall peak to peak, 1X (amplitude and phase). In a typical situation the OROS instrument is connected to the outputs of the monitoring system as shown in above figure.


Reciprocating Machines Diagnostics Module, EngineDiag

Integrate the machine mechanical properties and kinematics (number of cylinders, machine cycles, timing diagram) into NVGate, the Noise and Vibration software platform. The Advisor offers an easy software confi guration and results displays based on the machine characteristics and instrumentation.


Torsion & Twist for torsional vibration measurement and analysis

The Instantaneous angular Velocity Converter (IVC) provides instantaneous angular velocity signal to be analyzed.


Balancing: Single, Dual and Multiplane Vibration Balancing

OROS Balancing Solutions are software modules for balancing rigid and flexible rotors. These modules are well-suited for shop balancing or in-situ field balancing. They are designed to run on OROS analyzers

2 modules are available:


Spectral Based Diagnostics: FFTDiag

A complete toolset dedicated to machinery diagnostics: rotating machine trains, transmissions, gears and roller bearings